Skip to content
DIY with a shopping list

Project guides.

Practical plans that turn a renovation idea into measurements, a shopping list and a job you can finish.

01
Painting guide

How to Paint a Room: A Complete DIY Plan

Plan, prep and paint a room properly with a measurable material list, Ontario-friendly drying advice and products selected for each stage.

Beginner1 to 2 daysMeasured plan
02
Flooring guide

How to Install Vinyl Plank Flooring

A practical vinyl plank flooring installation plan covering layout, subfloor checks, waste calculations, expansion gaps and product selection.

Intermediate1 to 3 daysMeasured plan
03
Trim guide

How to Measure, Cut and Install Baseboards

Measure, plan and install baseboards with cleaner joints, accurate material quantities and a complete trim shopping list.

Intermediate1 to 2 daysMeasured plan
04
Bathroom vanity guide

How to Replace a 24-Inch Bathroom Vanity

Measure, remove and replace a compact bathroom vanity with a practical plumbing checklist, installation sequence and product-led shopping list.

Intermediate1 to 2 daysMeasured plan
05
Interior door guide

How to Measure and Replace an Interior Door

Choose between a slab and prehung interior door, measure the opening, plan handing and install the door and casing with fewer surprises.

Intermediate4 to 8 hoursMeasured plan
06
Tile floor guide

How to Tile a Bathroom Floor: Planning, Mortar, Grout and Sealing

Lay out, set, grout and seal a porcelain bathroom floor with the right mortar, levelling clips and sealant, with quantities you can measure before ordering.

Intermediate3 to 4 days including cure timesMeasured plan
07
Drywall repair guide

How to Repair and Patch Drywall: Nail Pops to Full-Sheet Patches

Fix nail pops, cracked corners, doorknob holes and larger damage with the right tape, compound and knife sizes, finished so the repair disappears under paint.

Beginner2 to 3 days with dryingMeasured plan
08
Door hardware guide

How to Install a Deadbolt and Door Lever on an Entry or Interior Door

Measure backset and bore, prepare a new or existing door, fit a single-cylinder deadbolt and a matching lever, and adjust the strike so the door latches cleanly.

Beginner1 to 2 hours per doorMeasured plan
09
Wet-area sealing guide

How to Re-caulk a Bathtub and Shower Without Mould Coming Back

Strip failed caulk, kill the mould behind it, dry the joint properly and lay a clean 100% silicone bead that stays white and watertight for years.

BeginnerHalf a day plus 24 hours cureMeasured plan
10
Hardwood flooring guide

How to Install Engineered Hardwood Flooring: Acclimate, Lay and Trim

Plan an engineered hardwood floor from subfloor prep and acclimation through nail-down or glue-down installation, expansion gaps, stair nosings and transitions.

Intermediate2 to 4 days plus acclimationMeasured plan
11
Crown moulding guide

How to Install Crown Moulding: Angles, Coping and Clean Corners

Measure a room for crown, set up the saw for the moulding’s spring angle, cope inside corners, mitre outside corners and fill, caulk and paint to a seamless finish.

Intermediate1 to 2 days for one roomMeasured plan
12
Sound control guide

How to Soundproof a Shared Wall with Mineral Wool and Resilient Channel

Cut noise through a bedroom, basement or townhouse wall by combining mineral wool insulation, resilient channel, a second layer of drywall and careful sealing.

Intermediate2 to 3 daysMeasured plan
Measure firstSimple quantities and waste allowances before you buy.
Follow the sequenceSteps arranged to reduce rework and missed preparation.
Shop the planProducts linked where they become relevant to the job.